Colours
All holds are made in these colours:
(red) |
(orange) |
(salmon pink) |
(violet) |
(blue) |
(green) |
(yellow) |
(white) |
(grey) |
(black) |
Slightly colour difference is not reason for claim.
AIX holds fly sheet
Climbing grips are intended for climbing on a outdoor and indoor climbing walls. The holds are made from polyester substance,
you can tag them to the specified places, which must be flat. The bolt size depending on anchorage technique.
For tightening you have to avail of hole size of anchor. If you will use the anchorage technique you have to
insure minimal bearing value of grips 200kg. All our grips have bolt hole with washer for wrench bolts M10
(except "mimicro" and Jibs, these sets have bolt hole for 5mm screws) If it is necessary, because of shape
of hold for exemple, we are using one wrench bolt and one 5 mm screw just to be sure.
The ceiling value of tightening torque is for holds with material size under washer to 1 cm 25 Nm, for the rest
of hold sis the ceiling value 40Nm. The tightening torque for sets like "mimicro" or "Jibs" is the ceiling value
10Nm.
You can clean the holds with steel brush, or if it is necessary you can use water (not hot) with detergent or vinegar
(max. 3%). When the hold get dry, it will keep its original firmness.
(yes) |
(yes) |
(no) |
1 t-nut/anchor
2 surface/wall
3 climbing grip
4 imbus bolt
Word document with fly sheet HERE